Ruger 10/22 Threaded Barrel Adapter – 1/2-28 – Stainless

This premium Ruger 10/22 Threaded Barrel Adapter has 1/2-28 threads and is Stainless Steel to securely hold your end of barrel devices
It quickly and easily slips on to the non-threaded barrel of your Ruger 10/22 so you can now run muzzle brakes, flash suppressors, compensators, sound suppressors, fake flash hiders, fake suppressors or any other legal end of barrel device with this highest-quality barrel thread adapter.
The largest diameter is a little larger than current A2 Birdcage and similar flash hiders.

Once on the barrel, you now have a fully threaded barrel, without the cost of going to a machinist or gunsmith to thread your barrel. It’s that simple!

Thread Adapter Features and Benefits

• Fits the following Ruger 10/22 models:
  • Ruger 10/22 Carbine
  • Ruger 10/22 Takedown
• Has a cutout to fit around the front iron sight.
• Threads: 1/2-28 TPI
• Thread Length: 5/8″
• Bore Depth: .9 inches
• Through Bore: Fits up to .25 caliber
• Diameter is a little larger than A2 birdcage-style flash hiders.
• Stainless steel for years of trouble-free service.
• Less expensive than going to a machinist or gunsmith
• Held in place with two set screws that are flush when tightened.
• Install this thread adapter on your non-threaded barrel in seconds and remove it just as quickly.
• This will fit the Ruger 10/22 ONLY! Don’t even try on something else. If you want something similar, go HERE

Designed, developed and manufactured in the United States using the finest U.S. Stainless Steel